Tonarm TA-1000

Since our start in 1996 we have received enquiries about tonearms for use with our Acoustic Signature turntables. We have had to recommend the finest arms from other manufacturers. After almost 20 years in which we have exclusively manufactured turntables we now added a new division. Since October 2014, we produce our own tone arms. Fine mechanic instruments produced to highest standards exclusive made in Germany. Why tone arms?

In recent years, the number of providers of affordable tone arms declined steadily and existing arms were regularly getting more expensive. The result is the TA 1000. A precisely manufactured prtecision-bearing tone arm. The TA 1000 is available in 3 lengths 9 inch, 10 inch and 12 inch.

3 available versions 9 inch, 10 inch and 12 inch

The Bearing

For the horizontal and vertical bearings only use precision miniature bearings from the German manufacturer SKF.  They are very expensive but manufactured to highest quality level. They are carefully selected. The precision bearings are ultra-precisely adjusted during the production process. The bearings are added with minimal pre pressure for zero backlash to achieve a minimum friction and maximum stability.

The Armtube

When it comes to arm tubes - 2 mutually exclusive conditions need to be combined. Maximum stiffness and low resonance achieved by internal damping. Very stiff materials are hard and therefore very susceptible to resonances. On the other side Low-resonance materials are not stiff enough. The solution is a Dual carbon tube. The two pipes are joined by connecting elements. This creates a very rigid tube but still having a high damping and resonance poverty and it is also very light weight.

The Cable

when you consider that the signals of a pickup are very small you can well imagine, any interruption and each solder joint makes the signal worse. So we have gone for the cabling of the TA 1000, to a Teflon insulated 6N copper cable which is continuously from the cartridge pins to the RCA plug. Without any interruption - in one piece. For customers who like to try different cables the TA 1000 is also available with 5 pin connector in the arm shaft.

Azimuth

To set up a pickup perfect it is required to compensate the possible misalignments of the diamonds and herewith do a proper adjustment of the angle. Many tone arms do not have this possibility. At the TA 1000 it can be done very comfortable and the solution is also very rigid and solid so we do not lose sound quality. At the end of Armtube shortly before the Bearing there is a adjustment option. For this you simply open 3 small screws and then the arm tube can be swivel for ± 5 degrees so the angle can be adjusted perfect for each cartridge. If these screws are again tightened the arm tube sits stiff and perfectly adjusted.

Technical data

Total length

9 inch       252 mm

10 inch     270,2 mm

12 inch     330,66 mm

Mounting Distance

9 inch       222 mm

10 inch     237,8 mm

12 inch     295,6 mm

The Cable

1.50m Direct wire, 6N Copper teflon insulated, RCA plugs

effective length

9 inch       237 mm

10 inch     254 mm

12 inch     318,1 mm

tilt angle

9 inch       22,00 degree

10 inch     21,60 degree

12 inch     17,30 degree

Effektive Mass

9 Zoll:  9,3gr.

10 Zoll:  9,7gr.

12 Zoll:   12,3 gr.

Mounting holes

Rega style, also available with SME mounting as a option

Brochure TA 1000
Brochure TA 1000  
Review TA 1000 HiFi News
TA 1000  
Review TA-1000 Image Hifi (english language)